IT-Passports.com のJuniperのJN0-533問題集はシラバスに従って、それにJN0-533認定試験の実際に従って、あなたがもっとも短い時間で最高かつ最新の情報をもらえるように、弊社はトレーニング資料を常にアップグレードしています。弊社のJN0-533のトレーニング資料を買ったら、一年間の無料更新サービスを差し上げます。もっと長い時間をもらって試験を準備したいのなら、あなたがいつでもサブスクリプションの期間を伸びることができます。
もしあなたはまだ合格のためにJuniper JN0-533に大量の貴重な時間とエネルギーをかかって一生懸命準備し、Juniper JN0-533認証試験に合格するの近道が分からなくって、今はIT-Passports.comが有効なJuniper JN0-533認定試験の合格の方法を提供して、君は半分の労力で倍の成果を取るの与えています。
JuniperのJN0-533認定試験を除いて、最近非常に人気がある試験はまたJuniper、Cisco、IBM、SAPなどの様々な認定試験があります。しかし、もしJN0-533認証資格を取りたいなら、IT-Passports.comのJN0-533問題集はあなたを願望を達成させることができます。試験の受験に自信を持たないので諦めることをしないでください。IT-Passports.comの試験参考書を利用することを通して自分の目標を達成することができますから。JN0-533認証資格を入手してから、他のIT認定試験を受験することもできます。IT-Passports.comの試験問題集を手にすると、どのような試験でも問題ではありません。
IT-Passports.comはたくさんIT関連認定試験の受験者に利便性を提供して、多くの人がIT-Passports.comの問題集を使うので試験に合格しますた。彼らはIT-Passports.comの問題集が有効なこと確認しました。IT-Passports.comが提供しておりますのは専門家チームの研究した問題と真題で弊社の高い名誉はたぶり信頼をうけられます。安心で弊社の商品を使うために無料なサンブルをダウンロードしてください。
難しいJN0-533認定試験に合格したいなら、試験の準備をするときに関連する参考書を使わないとダメです。自分に合っている優秀な参考資料がほしいとしたら、一番来るべき場所はIT-Passports.comです。IT-Passports.comの知名度が高くて、IT認定試験に関連するいろいろな優秀な問題集を持っています。それに、すべてのJN0-533試験問題集に対する無料なdemoがあります。IT-Passports.comのJN0-533問題集があなたに適するかどうかを確認したいなら、まず問題集のデモをダウンロードして体験してください。
試験番号：JN0-533問題集
試験科目：Juniper 「FWV, Specialist (JNCIS-FWV)」
問題と解答：全110問
購入前にお試し,私たちの試験の質問と回答のいずれかの無料サンプルをダウンロード：http://www.it-passports.com/JN0-533.html
NO.1 You want to set up a last resort route and prevent route lookups in either the source-based
routing table or the destination-based routing table.
What should you do?
A. Disable SIBR and create a default route in the trust-vr table using the null interface as the
outgoing interface with a higher metric than other routes.
B. Disable SIBR and create a default route in the trust-vr table using the null interface as the
outgoing interface with a lower metric than other routes.
C. Enable SIBR and create a default route in the SIBR table using the null interface as the outgoing
interface with a higher metric than other routes.
D. Enable SIBR and create a default route in the SIBR table using the null interface as the outgoing
interface with a lower metric than other routes.
Answer: C
Juniper認証試験 JN0-533参考書 JN0-533認定証 JN0-533認定証 JN0-533認証試験
NO.2 Click the Exhibit button.
Referring to the exhibit, what is the appropriate VPN monitor status?
A. The VPN is active and the peer is down.
B. The VPN is active and VPN Monitor is not configured for the peer.
C. The VPN is active and the peer is up.
D. The VPN is inactive and VPN Monitor is not configured for the peer.
Answer: B
Juniper認証試験 JN0-533 JN0-533 JN0-533参考書
NO.3 Which two configuration elements are synchronized between the members of an NSRP cluster?
(Choose two.)
A. interface IP addresses
B. hostname
C. track IP configuration
D. static routes
Answer: A,D
Juniper JN0-533認定証 JN0-533認定資格 JN0-533 JN0-533過去問
NO.4 You have configured integrated Web filtering in the ScreenOS software. A URL appears in the
blacklist, the whitelist, and a user-defined category. Additionally, the device can obtain
categorization information from the SurfControl server.
Which configuration will the device use to determine the action to take for Web requests for the
URL?
A. the blacklist
B. the SurfControl categorization
C. the user-defined category
D. the whitelist
Answer: A
Juniper JN0-533 JN0-533 JN0-533
NO.5 HostA is in the Trust zone and has an IP address of. ServerA is a Web server in the DMZ zone
and has an IP address of.
Which three configuration statements are required to allow traffic from HostA to communicate with
ServerA? (Choose three.)
A. ssg5-> set address Trust HostA / 32
B. ssg5-> set policy from DMZ to Trust ANY ANY ANY permit
C. ssg5-> set address DMZ ServerA / 32
D. ssg5-> set policy from Trust to DMZ HostA ServerA HTTP permit
E. ssg5-> set address Trust HostA / 32
Answer: C,D,E
Juniper JN0-533認定試験 JN0-533参考書 JN0-533過去問
NO.6 Which two statements are true about VPN Monitor on a ScreenOS device? (Choose two.)
A. With a route-based VPN failure, VPN Monitor marks the tunnel interface status as down.
B. With a policy-based VPN failure, VPN Monitor marks the tunnel interface status as down.
C. VPN Monitor uses UDP to detect a VPN connection failure.
D. VPN Monitor uses ICMP to detect a VPN connection failure.
Answer: A,D
Juniper JN0-533認定試験 JN0-533認定試験
NO.7 Which two statements are true about policy-based VPNs as compared to route-based IPsec
VPNs when using ScreenOS devices? (Choose two.)
A. For policy-based IPsec VPNs, you can configure 0.0.0.0/ 0 as the proxy ID on both VPN gateways
regardless of the security policy.
B. For route-based IPsec VPNs, you can configure 0.0.0.0/ 0 as the proxy ID on both VPN gateways
regardless of the security policy.
C. For route-based IPsec VPNs, the proxy ID is derived from the policy.
D. For policy-based IPsec VPNs, the proxy ID is derived from the policy.
Answer: B,D
Juniper JN0-533参考書 JN0-533 JN0-533 JN0-533問題集
NO.8 Click the Exhibit button.
Which two statements are true regarding the route shown in the exhibit? (Choose two.)
A. 5.5.5.0/ 24 was configured as a source route with a next-hop IP address of 1.1.1.1 in the trustvr.
B. 5.5.5.0/ 24 was configured as a destination route with a next-hop IP address of 1.1.1.1 in the
trust-vr.
C. 5.5.5.0/ 24 was configured as a SIBR route with a next-hop IP address of 1.1.1.1 in the trust-vr.
D. 5.5.5.0/ 24 was configured as a permanent source route.
Answer: A,D
Juniper参考書 JN0-533練習問題 JN0-533参考書 JN0-533認定資格
NO.9 -- Exhibit -set admin name "admin" set admin password "nOsYMqrbAs/McFsJrs6HwcIt3AF6yn"
set admin user "User1" password "nLZwKErINPPCcphC6sFMXrJ" privilege "read-only" set admin port
8080 set admin access attempts 5 set admin access lock-on-failure 5 set admin auth web timeout 10
set admin auth server "Local" -- Exhibit -
User1 wants to create the policy in the ScreenOS device, but is not successful. Referring to the
exhibit, what is the problem?
A. The User1 account has been suspended.
B. User1 does not have any account in this device.
C. User1 logged in to the device with wrong port.
D. User1 does not have the proper permission to create a policy.
Answer: D
Juniper認定証 JN0-533 JN0-533 JN0-533
NO.10 Click the Exhibit button.
In the exhibit, you have configured the MIP address 1.1.8.64 on a ScreenOS device.
Which statement is correct?
A. It performs one-to-one address translation and maps 1.1.8.64 to 10.1.10.64.
B. It performs one-to-many address translation and maps 1.1.8.64 to a range from 10.1.10.64 to
10.1.10.71.
C. It performs range address translation and maps 1.1.8.64 to 10.1.10.64, 1.1.8.65 to 10.1.10.65,
etc..
D. It performs address translation using a random IP address from the pool for 10.1.10.64 / 29.
Answer: C
Juniper JN0-533認定試験 JN0-533認定証
IT-Passports.comは初めて試験を受けるあなたが一回で試験に合格して、認証資格を取ることを保証します。IT-Passports.comが提供して差し上げたのは高品質のJuniperのJN0-533模擬問題集で、あなたがステップバイステップで試験に準備する手順を指導しています。IT-Passports.comのJuniperのJN0-533試験問題集は絶対あなたに成功をもたらすことを保証します。IT-Passports.comのJuniperのJN0-533認定試験に準備するために色々な方法がありますが、
没有评论:
发表评论